Vespa

Small diameter centerstand boots for handlebar Vespas that take boots, VNA, and GS150. Inside diameter of boots ~14mm

Clip attaches crest to front fender (two required). Fits all 1960 thru 1980's Vespas.

Prima Battery 12N5.3B for Vespa VNX, VSX or V9B vintage Vespa scooters. Dimensions: 5.3 x 2.4 x 5.1 inches ***Please note*** Ships *without* acid. ...

Plastic bushing where front cowl pin goes into the frame. Fits all post '58 largeframe Vespas with removeable cowls, except for P-series, which tak...

Vintage Vespa Flywheel Cover - Large FrameProtect your engine and maintain optimal cooling with this high-quality replacement flywheel cover. Desig...

Complete carburetor rebuild set for your Dellorto SI 20mm or 24mm carburetor. This is a complete set that includes the necessary parts for rebuildi...

The rubber plug that goes in the back of the carb box on all post '58 largeframe Vespas except GS/SS models. Looking for more rubber parts? We also...

Spaco/Dellorto 20/15 SI carburetor for vintage largeframe Vespas and Genuine Stella scooters. See the compatibility table below to ensure this pro...

Gasket, Oil Drain Bolt. Fits the drain bolt on all vintage Vespas except GS160/SS180, and fits the fill hole on all vintage Vespas. So unless you h...

Slack / tension adjuster for manual-transmission Vespa, Sears Allstate, and Genuine Stella 2T and 4T rear brake cables.

Rubber gas cap gasket for most large frame model Vespa scooters with a folding-type gas cap. P/PX-series scooters and Genuine Stella scooters do no...

A circlip or snap ring is a type of fastener consisting of a semi-flexible metal ring with open ends which can be snapped into place, into a machin...

Replace the battery on your Vespa P/PX, ET4, or Genuine Stella with this Prima 12V CB9-B battery. Maintenance-free sealed lead-acid design. Ships d...

Brake link plate for most vintage Vespa scooters.

Upholstery clips keep your seat cover in place. 18 recommended. Fits all 1970's 1980's Vespas

Black rubber strap for securing the battery on most vintage smallframe and largeframe Vespa scooters. See the compatibility table below to ensure t...

"Vespa GL" legshield emblem. Requires 8 rivets , sold separately.

European fuel control replacement for small frame Vespas includes fuel rod, frame grommet, gasket, plate and two screws. Fits VMA2 and V9B.

Gasket set for vintage Vespa Rally 180 scooter

"Vespa" script legshield emblem. Fits Rally 180 and some Supers.

Piston 57.2 mm for 3 port Vespa 150 cc First over

Front fender for VSE, VSD and VLB. This is a primered, unpainted part. The color of the primer may vary, and there may be surface scratches from st...

External ignition coil. Fits Rally 200. Please note: Very late model Rally (1977-78) used the P-Series CDI instead. If you have a late Rally, pleas...

Flywheel-side crankshaft bearing for VSD and VSE (Rally) model vintage Vespas.