Bolts

Short but heavy bolt for securing the halves of your engine case together. To paraphrase Elwood Blues,"Strong stuff."

This is the long bolt that goes through the spring on 1960s era vintage Vespa saddle seats.

Long bolt that holds in the front of the small frame engine. Use S 20010 for the nut and S 16410 for the washer.

Wheel to hub bolt. V5A-V9A '64-65

Standard kickstart lever bolt for most vintage Vespa scooters.

Gasket, Oil Drain Bolt. Fits the drain bolt on all vintage Vespas except GS160/SS180, and fits the fill hole on all vintage Vespas. So unless you h...

Headset securing bolt for most 70s Vespas attaches headset to steering column. Square nut 70620 sold separately.

Bolt for mounting rear turn signals on P series Vespas. 2 required per turn signal. For securing nuts, use S 20104 .

Washers for pivot bolts of clutch and front brake levers. (One required for each pivot bolt). To replace all lever washers, two 97733 and two 17492...

Cable clamp for rear brake cable.

Standard cylinder shroud bolt for vintage Vespa VSE model scooters.

ong heavy bolt for securing the halves of your engine case together. To paraphrase Elwood Blues,Strong stuff. Used for vintage Vespa scooters. VNA ...

Long 9mm bolt used to fasten a rear shock on most vintage Vespa large frame scooters. Don't forget your washers, nuts and buffers when ordering.

Bolt (Muffler, Long)

Bolt securing carburetor to air box (two required). Fits most large frame vintage Vespa and Sears Allstate scooters with manual transmission. Washe...

Standardfront shock upper bolt for most vintage Vespa scooters.

Standard front shock bolt for all largeframe vintage Vespas except P/PX, GS160, and SS.