Vespa

Inner rear brake cable with loop. For post-1979 oil-injected Vespas.

Silver powdercoated split rim (3.5 x 8) for vintage Vespa largeframe scooters with 8" rims. Specifications:Overall dimensions: 8"L x 8"W x 3.5"HCom...

Oil seal for clutch side for vintage Vespa small frame scooters.Looking for more seals for your bike? This seal is also available in the Small Fram...

Air filter securing screw. Fits VNL1, VNC, VNX, VLB, VBC, VSE, VSD, VLX, VSX and Stella 2T.

A circlip or snap ring is a type of fastener consisting of a semi-flexible metal ring with open ends which can be snapped into place, into a machin...

Gasket, Oil Drain Bolt. Fits the drain bolt on all vintage Vespas except GS160/SS180, and fits the fill hole on all vintage Vespas. So unless you h...

  Rubber gas cap gasket for most large frame model Vespa scooters with a folding-type gas cap. P/PX-series scooters and Genuine Stella scooters do...

Slack / tension adjuster for manual-transmission Vespa, Sears Allstate, and Genuine Stella 2T and 4T rear brake cables.

Small 8mm stud threaded on both ends. For fastening wheel rim to hub on most vintage Vespa scooters with 10in wheels. Both Front and Rear.

Fits 1960's & 1970's largeframe Vespas.

Fits all vintage Vespas.While you're at it, you may need these as well:Sku: 4435 (Gas Cap Nut Pin Rod)Sku: 2319 (Gas Cap Gasket, Vespa LF)Sku: S 03...

Vintage Vespa Flywheel Cover - Large FrameProtect your engine and maintain optimal cooling with this high-quality replacement flywheel cover. Desig...

The rubber plug that goes in the back of the carb box on all post '58 largeframe Vespas except GS/SS models. Looking for more rubber parts? We als...

Remove the castellated clutch nut on Genuine Stella 2T/4T and all large-frame Vespa models with this purpose-built Universal Parts Clutch Nut Tool....

Rubber plug for the flywheel points hole in the flywheel. fits VNC, VBC, VLB, VSD, VMA, V9A. Looking for more rubber parts? We also have a basic r...

Fits models: V5A*     Vespa 50                            63 - 83  50           Small Frame  V5B        Vespa 50 Special              72 - 83  50...

A very handy tool for taking apart your clutch. Compresses the springs gradually so you can remove the circlip. For all largeframe Vespa clutches.

Four speed selector box with no neutral hole for vintage scooters.

A Woodruff key is a semicircular shaped, removable key that fits into a matching keyway cut into a shaft, leaving a protruding tab. The tab mates w...

Clutch spring cup for most large frame Vespa scooter models with manual transmission. Also fits Genuine Stella 2T scooters.

Grommet where the spark plug wire comes out of the case on all vintage Vespa scooters with an internal ignition coil and manual transmission.

Black kickstart rubber for GS150 and handlebar bikes that take a kickstart rubber. For all other models, use 49642.

Gas cap assembly that fits fuel tanks from VM1, VNC1, VL1-3, VBA-C, VLA-B, VS2-5, VNL2, and P-series vintage Vespa scooters.For pin rod, knob and c...