OEM Parts

Reliable Restoration: Blue Line OEM-Spec Variator Assembly Restore your scooter’s smooth acceleration with the Blue Line Variator Assembly . Desi...

Is your GS 150's kickstart lever feeling a little "floppy"? You might need a new return spring. This will do the job.

Shield your scooter's footrest paintwork from unsightly scratches, scuffs, road grit, and moisture with the genuine Original Piaggio Rubber Floor M...

Blue Line's long transmission/crankcase cover gasket for the left side of GY6 engines has 10 bolt holes and fits most GY6 bikes with 12" or 13" whe...

Exhaust valve for GY6 150cc engines. Face: 22.9mm Length: 65.3mm Product is intended as OEM equivalent for listed models. Any misuse, alteration or...

Cylinder, and base gasket, for a stock GY6 150cc engine. Piston and wrist pin not included. Cylinder head sold seperately ( 1100-1225 ). *Not a sto...

Bezel for front fender headlight. 95mm in diameter. Early Allstate w/o Speedo Hole.

Cylinder head gasket for GY6 engines.

Piston for stock GY6 150cc engines. Rings(1100-1234) and wrist pin parts(1100-1193,1100-1194) sold seperately. Product is intended as OEM equivalen...

Stock GY6 transmission clutch and pulley assembly, without clutch bell. This kit includes all the parts that commonly fail in a stock Chinese clutc...

OEM set of piston rings for stock GY6 150cc engines. Original Parts For Scooters SKU 164-99 Specifications: Thin Ring Thickness: 0.4mm Thin Ring Wi...

OEM GY6 57.4mm cylinder head with valve guides. NOTE: Not a stock replacement for Genuine Buddy scooters. Use SKU C5071011000 instead. Original Par...

Valve cover gasket for GY6 engines (Supersedes SKU 1100-1057). Original Parts For Scooters SKU 164-24 Compatibility: 157QMJ-based 125cc / 150cc / 1...

This OEM rear drum brake actuator dust cover fits GY6 bikes. Original Parts For Scooters SKU 100-226 Specifications: Rubber with metal hook Compati...

Intake valve for GY6 150cc engines. Original Parts For Scooters SKU 164-178 Specifications: Valve Diameter: 27.75mm  Length: 66mm  Compatibility:...

Small rubber buffer that keeps the door near the fuel valve on handlebar bikes and GS150 from rattling. Sold invividually (4 required). From Mauro ...

Rubber buffer that goes in the rear engine case where the shock bolt goes through. Fits Vespa P125, PX150, and P200 scooters.

Oil Pump Drive Gear for oil-injected 70s scooters (Super,Sprint,Rallys) except P-series. Located on clutch side of crankshaft.

Headlamp bezel for 1970's USA Models: VSE, VSD, VBC, VLB, VMA and V9A. Requires three screws (S 15544) sold separately.

Flywheel-side rear axle bearing for small frame scooters.

Feel lucky? This is the same as the factory trim for post-50s Smallframe Vespas, but it ain't easy to install. This aluminum legshield trim require...